Pressure adjustment method of die cutting machine:
1. The positions of the two claw blocks and the gear plate can be adjusted. The claw blocks move upwards. The pressure increases and shears each action of the claw block. The distance between the two surfaces changes by about 0.1 mm, usually There is only one tooth when acting.
　　2. When the claw block is at the last tooth of the tooth plate, you should consider replacing the new gear and eccentricity. The following methods can be used to adjust: loosen the screw to loosen the gear eccentricity adjustment plate, and the gear wrench to eccentricity of the back gear. Then note: The number of teeth must be rotated equally on both sides, and the rotation should not exceed three teeth. The installation tooth adjustment plate, screw, and claw block will be adjusted to the first tooth. Looking at the shear pressure effect, the effect is not satisfactory. You can make adjustments. You should pay attention to the teeth of the eccentric rotating gear, which should be smaller than the first rotation. the teeth of. When the pressure on the left or right is too small, this method can also be used, that is, adjust which side of the gear is eccentric with a small pressure, try to reduce the claw block and return the 1-2 teeth appropriately.
3. When the upper and lower parts of the pressure, release the pad and the hook-type fastening plate to adjust the screw block, the hook-type pad increases the thickness of the gasket while reducing the thickness of the plate in the tone block, facing increasing pressure. Surface unit; on the contrary, low pressure.