The working principle of die cutting machine:
Die Cutting Machine (Die Cutting Machine) is also called beer machine, numerical control, servo hydraulic press, mainly used for the corresponding die-cutting of some non-metallic materials, stickers, EVA, double-sided tape, electronics, mobile phone protective film, etc. (Fully broken, half broken), indentation and bronzing operations, laminating, automatic waste removal, die-cutting machine uses steel knives, metal molds, steel wires (or templates carved from steel plates) to apply a certain pressure through the embossing plate , The printed product or cardboard is rolled and cut into a certain shape. If the entire printed product is press-cut into a single graphic product, it is called die-cutting: if a steel wire is used to make a mark on the printed product or a bend is left, it is called an indentation; if two stencils of male and female are used, the mold Heat to a certain temperature. Hot stamping of patterns or fonts with a three-dimensional effect on the surface of the printed product is called hot stamping; if one substrate is used to overlay another substrate, it is called laminating; except for the rest, it is called waste disposal; the above can be Collectively referred to as die-cutting technology, it is an important equipment for post-press packaging processing and shaping.
The working principle of 　　 die-cutting machine is to use die-cutting tools, steel knives, metal molds, steel wires (or plates carved from steel plates), and apply a certain pressure through the pressure plate to cut the printing plate or cardboard into a certain shape. If the entire product is pressed into a graphic product, it is called die cutting; if it is called indentation, use a steel wire to press the logo to print or ditch to the left. If you use two molds of Yin and Yang to heat to a certain temperature, a pattern or font has a three-dimensional effect. The printing on the surface is called bronze. If the fruit is replaced by another substrate, another part of the product is called waste disposal; the above are collectively referred to as die cutting technology.
The process of die-cutting machine is the most commonly used process for packaging printed materials. It uses a die-cutting knife to form a die-cutting plate according to the pattern required by the product design. Under pressure, the printed matter or other ring-packed blanks are rolled and cut into the required The shaping process of shapes or cut marks. The creasing process is to use a crimping knife or a crimping die to make a line mark on the sheet through the action of pressure, or use a rolling wheel to bend and shape the board at a predetermined position. Usually, the die-cutting and creasing process is a process of combining the die-cutting knife and the crimping knife in the same template, and simultaneously performing die-cutting and creasing processing on the die-cutting machine, which is called die-cutting for short. Process introduction The main process of die-cutting indentation is: loading the plate-adjusting the pressure-determining the rules-pasting the base material accessories-test pressure die cutting-formal die cutting indentation-removal-finished product hand-rolled or cut into pieces-point packaging.